GEOS GCM Documentation and Access

This page describes the minimum steps required to checkout GEOS-5 AGCM.

Checking Out GEOS-5 AGCM using subversion

The commands below assume that you have a svn client installed on your machine. In order to compile GEOS5 AGCM you need to have a Fortran 90 compiler available.

The first thing you need to do is to register in the GEOS5 trac system using the following link:

http://geos5.org/trac

In order to access the SVN repository as a developer, you need to be approved by the GEOS5 AGCM maintainer at the following email address: matthew.thompson@nasa.gov

Once approved, you will be able to checkout the source code with the following command:

 svn --username <myusername> checkout http://geos5.org/svn/branches/Ganymed-4_1/ GEOSagcm

You can create tickets through the trac system and contribute to the code.

Boundary Conditions

Boundary conditions are available at NCCS, NAS, and on GMAO Desktops (limited to very low-res).

A minimal, small set of boundary conditions of approximately 300 MB have been made and could possibly be distributed if needed. Contact Matthew Thompson for further inquiries.